Endress+Hauser Proline Promag W 800 - Page 26

Installation Proline Promag W 800
26 Endress+Hauser
6.2.2 Installing the wall-mount housing
There are various ways of installing the wall-mount transmitter housing:
• Direct wall mounting
• Pipe mounting (with separate mounting kit, accessories)→  27
"
Caution!
The permitted operating temperature range may not be exceeded or undershot.
Note the following points:
• Install the measuring device in a shady location. Avoid direct sunlight, particularly in warm
climatic regions.
• The transmitter must be mounted separate from the sensor if both the ambient and fluid
temperatures are high.
Direct wall mounting
1. Drill the holes as illustrated in the graphic.
2. Screw in the securing screws slightly at first.
3. Fit the transmitter housing over the securing screws and mount in place.
4. Tighten the securing screws.
A0016411
Fig. 15: Direct wall mounting
149 (5.85)
210.5 (8.29)
=
5.8 (0.23)
mm (in)
18 (0.71) =
14 (0.55)
5.8 (0.23)