Endress+Hauser Proline Promass I 300 - Input Values Submenu

Proline Promass I 300 PROFINET Operation
Endress+Hauser 145
Parameter overview with brief description
Parameter Prerequisite Description Selection / User entry /
User interface
Assign process variable – Select process variable for totalizer. • Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
• Condensate mass flow
• Energy flow
• Heat flow difference
Totalizer value 1 to n In the Assign process variable
parameter one of the following options
is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
• Condensate mass flow
• Energy flow
• Heat flow difference
Displays the current totalizer counter
value.
Signed floating-point
number
Totalizer status 1 to n – Displays the current totalizer status. • Good
• Uncertain
• Bad
Totalizer status (Hex) 1 to n In Target mode parameter, the Auto
option is selected.
Displays the current status value (hex)
of the totalizer.
0 to 0xFF
11.4.3 "Input values" submenu
The Input values submenu guides you systematically to the individual input values.
Navigation
"Diagnostics" menu → Measured values → Input values
‣
Input values
‣
Current input 1 to n
→  145
‣
Status input 1 to n
→  146
Input values of current input
The Current input 1 to n submenu contains all the parameters needed to display the
current measured values for every current input.
Navigation
"Diagnostics" menu → Measured values → Input values → Current input 1 to n
‣
Current input 1 to n
Measured values 1 to n
→  146
Measured current 1 to n
→  146