Endress+Hauser Proline Promass I 300 - Configuring the Current Input

Proline Promass I 300 PROFINET Commissioning
Endress+Hauser 99
Navigation
"Setup" menu → I/O configuration
‣
I/O configuration
I/O module 1 to n terminal numbers
→  99
I/O module 1 to n information
→  99
I/O module 1 to n type
→  99
Apply I/O configuration
→  99
I/O alteration code
→  99
Parameter overview with brief description
Parameter Description User interface / Selection / User entry
I/O module 1 to n terminal numbers Shows the terminal numbers used by the I/O module. • Not used
• 26-27 (I/O 1)
• 24-25 (I/O 2)
• 22-23 (I/O 3)
I/O module 1 to n information Shows information of the plugged I/O module. • Not plugged
• Invalid
• Not configurable
• Configurable
• PROFINET
I/O module 1 to n type Shows the I/O module type. • Off
• Current output
*
• Current input
*
• Status input
*
• Pulse/frequency/switch output
*
• Double pulse output
*
• Relay output
*
Apply I/O configuration Apply parameterization of the freely configurable I/O module. • No
• Yes
I/O alteration code Enter the code in order to change the I/O configuration. Positive integer
* Visibility depends on order options or device settings
10.5.6 Configuring the current input
The "Current input" wizard guides the user systematically through all the parameters that
have to be set for configuring the current input.
Navigation
"Setup" menu → Current input
‣
Current input 1 to n
Terminal number
→  100