Endress+Hauser Proline Promass I 300 - Post-Connection Check

Electrical connection Proline Promass I 300 PROFINET
48 Endress+Hauser
4. Firmly tighten the cable glands.
5. To ensure that moisture does not enter the cable entry:
Route the cable so that it loops down before the cable entry ("water trap").

A0029278
6. Insert dummy plugs into unused cable entries.
7.7 Post-connection check
Are cables or the device undamaged (visual inspection)? 
Do the cables used meet the requirements? 
Do the cables have adequate strain relief? 
Are all the cable glands installed, firmly tightened and leak-tight? Cable run with "water trap"
→  47?

If supply voltage is present, do values appear on the display module? 