Endress+Hauser Proline Promass I 300 - Configuring the Pulse;Frequency; Switch Output

Proline Promass I 300 PROFINET Commissioning
Endress+Hauser 105
10.5.9 Configuring the pulse/frequency/switch output
The Pulse/frequency/switch output wizard guides you systematically through all the
parameters that can be set for configuring the selected output type.
Navigation
"Setup" menu → Advanced setup → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  105
Parameter overview with brief description
Parameter Description Selection
Operating mode Define the output as a pulse, frequency or switch output. • Pulse
• Frequency
• Switch
Configuring the pulse output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  106
Terminal number
→  106
Signal mode
→  106
Assign pulse output
→  106
Value per pulse
→  106
Pulse width
→  106
Failure mode
→  106
Invert output signal
→  106