Endress+Hauser Proline Prosonic Flow P 500 - Mounting Procedures; Mounting Requirements and Considerations; Mounting Position Details

Proline Prosonic Flow P 500
Endress+Hauser 19
Output
Output and input variants
Depending on the option selected for output/input 1, different options are available for the other
outputs and inputs. Only one option can be selected for each output/input 1 to 3. The following
tables must be read vertically (↓).
Example: If the option BA "4–20 mA HART" was selected for output/input 1, one of the options A, B,
D, E, F, H, I or J is available for output 2 and one of the options A, B, D, E, F, H, I or J is available for
output 3.
Output/input 1 and options for output/input 2
Options for output/input 3 →  20
Order code for "Output; input 1" (020) → Possible options
Current output 4 to 20 mA HART BA
Current output 4 to 20 mA HART Ex i passive ↓ CA
Current output 4 to 20 mA HART Ex i active ↓ CC
Modbus RS485 MA
Order code for "Output; input 2" (021) → ↓ ↓ ↓ ↓
Not used A A A A
Current output 4 to 20 mA B B
Current output 4 to 20 mA Ex i passive C C
User-configurable input/output
1)
D D
Pulse/frequency/switch output E E
Pulse output, phase-shifted
2)
F F
Pulse/frequency/switch output Ex i passive G G
Relay output H H
Current input 0/4 to 20 mA I I
Status input J J
1) A specific input or output can be assigned to a user-configurable input/output →  25.
2) If "pulse output, phase-shifted" (F) is selected for output/input 2 (021), only the "pulse output, phase-shifted" (F) option is available for selection
for output/input 3 (022).