Endress+Hauser Solicap M FTI56 - Page 86

Technical data Solicap M FTI55, FTI56
86 Endress+Hauser
10.5.2 Process pressure and temperature derating
!
Note!
• The lowest value from the derating curves of the device and the selected flange applies.
• In the case of flange process connections, the maximum pressure is limited by the nominal
pressure of the flange.
• See also "Process connections" on Page 18 ff.
Rod probe FTI55
TI418F64
Partially insulated (PPS):
TI418F65
Fully insulated (PE):
Rope probe FTI56
TI418F64
Partially insulated (PTFE):
barbar
PP
pp
00
–40–40 –20–20–60–60
8080 120120 160160 180180 200200
4040
2020
2020 4040 6060 100100 140140
TT
PP
°C°C
00
barbar
PP
pp
00
–40–40 –20–20–60–60
4040
2020
2020 4040 6060 8080 100100
TT
PP
°C°C
00
barbar
PP
pp
00
–40–40 –20–20–60–60
8080 120120 160160 180180 200200
4040
2020
2020 4040 6060 100100 140140
TT
PP
°C°C
00