In -Prog- mode:
KEY 3s (RETURN TO FACTORY PROGRAMMING)
Allows entering a code of access to the reset of the configuration parameters, this code is 74. When entering this code the
instrument shows the LoAdIng dEFAuLt ConFIGurAtIon legend, following StorE, which means that they have been stored in the
non volatile memory of the instrument.
DIRECT ACCESS TO SETPOINTS – KEY
Now, in case any of the 2 Relais SPDT, 4 Relais SPST, 4 Sorties NPN, 4 Sorties PNP, options has been installed, the instrument
allows a direct access to the programming of the setpoints value, pressing the key sequentially for each one of the setpoints
values available according the option installed.
INPUT:
600 V DC
DISPLAY
Input 1: 0000.0 Display 1: 0000.0
Input 2: 600.0 Display 2: 600.0
Filter P: 0
Round: 01
Brightness: High
Eco: oFF
DISPLAY COLORS
Run Mode: Green, Prog Mode: Amber
SETPOINTS
Setpoint 1: 0100.0, Setpoint 2: 0200.0
Setpoint 3: 0300.0, Setpoint 4: 0400.0
Mode: HI
Dly: 00.0
Alarm Color: No Change
ANALOG OUTPUT CONFIGURATION
Display HI: 1000.0
Display LO: 0000.0
LOGIC FUNCTIONS
PIN 2=function 3, PIN 3=function 4 and PIN
4=function 6
To Next Page
Loading...