Enerdis C.A 2150-E - 6 Programming Lock out by Software

28
6 PROGRAMMING LOCK OUT BY SOFTWARE
The instrument is delivered with the programming locked out, giving access to all the programming levels. Once completed the
instrument programming we recommend the following security measures be taken:
1- Lock out the programming access to prevent from programmed parameters modifications.
2- Lock out keyboard functions to prevent from accidental modifications.
3- There are two lockout modes: selective and total. If the parameters are going to be readjusted frequently, make a selective
lockout. If no adjustment is going to be made, make a total lockout. Keyboard functions lockout is always possible.
4- The access to the lockout routine is allowed by entering a personalised code. We recommend changing the code set at factory
and to write down your personalised code and keep it in a safe place.
TOTAL LOCKOUT
The access to the programming routines to read data is allowed even if all parameters are locked out totLC=1, but it won’t be
possible to enter or modify data. In this case, when entering in the programming mode, the display shows the indication "-
dAtA-".
PARTIAL LOCKOUT
When only some parameters are locked out, all configuration data can be read but only non protected parameters can be
modified. In such case, when entering in the programming mode, the display shows the indication "-Pro-".