ENGBO AS – et selskap i Engbo-gruppen
BESØKSADRESSE: Wirgenesvei 7, 3157 Barkåker POSTADR: Postboks 2288 Postterminalen, 3103 Tønsberg
E-MAIL: support@engbo.no WEB: www.engbo.no TLF: +47 33 00 31 50 FAKS: +47 33 00 31 60
Hull conduit / Line guide
It will often be necessary to install a hull conduit with a
pulley that guides the rope with low friction through the
hull.
The hull conduit will also prevent large volumes of water
from leaking in. (When fitting the MAXI 34V or MAXI 40 on
the inside of the stern, it will often be possible to adjust
the hull conduit so as to prevent friction between the hull
and the rope.)
Anchor rope
Engbo supplies original woven anchor rope with a lead
core in the whole length of the rope along with a fine
special thimble that will not snag on the pulley or bracket
when the anchor is dropped. This rope has been specially
designed for Engbo anchor windlasses and is a
precondition for problem-free operation of the system.
Supplied in various lengths and dimensions. The Engbo
Maxi range generally uses 16 mm line. If the available
space for storing the line is limited, 14mm line could be an
alternative.
To Next Page
Loading...
