EasyManua.ls Logo

Engbo MAXI 40 - Maintenance; Replace Wireless Remote Batteries

Default Icon
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGBO AS et selskap i Engbo-gruppen
BESØKSADRESSE: Wirgenesvei 7, 3157 Barkåker POSTADR: Postboks 2288 Postterminalen, 3103 Tønsberg
E-MAIL: support@engbo.no WEB: www.engbo.no TLF: +47 33 00 31 50 FAKS: +47 33 00 31 60
36
9
10
NB When you have used the windlass several times, the line may have stretched slightly,
resulting it may be lying a little deeper in the line wheel. If the anchor does not seat firmly in
the anchor bracket, you may need to post-adjust the brass wire indicator that signals the
second auto stop.
Maintenance
Replacing the batteries in the wireless remote control
The remote control uses three standard AAA/LR03
alkaline batteries. For normal operation, the
batteries have a service life of more than two
seasons.
To change the batteries, remove all five screws to
open the remote control.
NB The screws are different lengths and have O-
rings under their heads.
Replace the used batteries with new ones and
make sure that they are installed correctly (+ up
and down towards the bottom edge) as shown in
the picture.
Replace the rear cover and carefully screw the
sections together until the gasket between the
sections is gently compressed.
The water-tightness of the remote control unit is
dependent on intact O-rings and undamaged,
correctly compressed packing.
NB To ensure a long service life, the remote
control unit features acid-resistant machine screws
and threaded bushes in the top cover.
Careless, excessive turning can force these screws
through the top cover.
(Not covered by the warranty).

Table of Contents

Other manuals for Engbo MAXI 40

Related product manuals