ENGBO AS – et selskap i Engbo-gruppen
BESØKSADRESSE: Wirgenesvei 7, 3157 Barkåker POSTADR: Postboks 2288 Postterminalen, 3103 Tønsberg
E-MAIL: support@engbo.no WEB: www.engbo.no TLF: +47 33 00 31 50 FAKS: +47 33 00 31 60
Maxi 32 box
NB The Engbo line / chain box is supplied complete with
predrilled holes.
Drill a hole for the cables and run these through the
hull. Use Sikaflex or similar to seal the hole for the
cables.
Connect the cables according to the electrical
connection diagram.
When fitting the fibreglass box, the open end must be
adapted to the shape of the stern and fixed in position
using through-and-through bolts to connect the angle
bracket supplied directly to the hull. Adjust the brackets
to the correct angle and fix them internally, at the top
and bottom of the side panel of the box.
Run the rope via the line wheel on the windlass, down
through the rope/chain guide and under the line wheel.
Use the windlass to wind it up.
NB The length of the box must be at least 40 cm.
NB Remember to secure the end of the rope/chain to
the inside of the box. (Drill a hole through the bottom of
the box and through the platform, and then fit the
bracket supplied. Remember to drill holes in each of the
lower stern corners for drainage purposes.)
NB The box is normally sufficient for 50 m x 16 mm
rope or 30 m chain.
To Next Page
Loading...
