ENGBO AS – et selskap i Engbo-gruppen
BESØKSADRESSE: Wirgenesvei 7, 3157 Barkåker POSTADR: Postboks 2288 Postterminalen, 3103 Tønsberg
E-MAIL: support@engbo.no WEB: www.engbo.no TLF: +47 33 00 31 50 FAKS: +47 33 00 31 60
NB If the windlass is straining while raising the anchor, it
would be a good idea (and save power) to run the windlass
in periods. Once the boat has begun to move backwards,
you can release the up button and then run the windlass in
periods.
Release the up button, press again and keep
depressed.
The windlass will continue to raise the anchor slowly
until the second auto stop is activated, stopping the
windlass completely.
The anchor will then be correctly seated in the anchor
bracket.
Attach the safety line to the anchor.
Turn off the main switch of the windlass.
Have pleasant sailing!
Wireless remote control
To switch on the remote control, keep one of the
buttons depressed for 1.5 sec. The green “power”
indicator will light up, and you will hear a brief audio
signal.
Every time you subsequently press a button, the
associated indicator will light up, and the remote will
emit an audio signal.
To ensure a long lifetime, the remote control switches
off automatically 5 min. after the last button was
pressed. Automatic shut-off is preceded by two short
audio signals and the “Power” indicator flashing.
To Next Page
Loading...
