EnGenius ENH210EXT User Manual

About This Document
This document is written by EnGenius Inc. EnGenius Inc. the reserves the right to change this
document without notice and all rights are reserved. This document can only be used for the
configuration of EnGenius products.
This document is to characterize the EnGenius ENH210EXT Wireless Access Point & Client
Bridge. Please read the document carefully before setting up the ENH210EXT. Any damage
which is caused by inappropriate use will not be covered under the warranty.
This document uses following symbols to indicate and highlight special messages.
Formats
Caution: This symbol represents a vital message and it is critical for the device
or settings.
Note: This symbol represents an important message for the settings.
Tip: This symbol represents an alternative choice that can save time or
resources.
The following equipment is required to setup the ENH210EXT:
Before you start__________________________________________________
1. (1) Computer/Notebook and Internet access.
2. (2) Ethernet cables.
3. (1) EnGenius ENH210EXT.
The equipment listed above is only for configuration of the ENH210EXT, you
will need additional equipment to connect to the Internet and configuration will depend on
your current network infrastructure. Please refer to Chapter 2 for more information.

EnGenius ENH210EXT Specifications

General

Brand	EnGenius
Model	ENH210EXT
Category	Wireless Access Point
Language	English