124
WSG-1068 ENGINE
Cylinder Head - Assembly
1.
CAUTION: Mating parts must make contact
to each other within 4 minutes and connecting
bolts must be torqued within 15 minutes after
applying sealant. Failure to follow this procedure
can cause future oil leakage.
Use silicone gasket and sealant F6AZ-19562-AA
or equivalent meeting Ford specification WSEM4G323-
A6.
NOTE: Sealant must be removed and area cleaned with
solvent if above instructions are not followed.
Use metal surface cleaner F4AZ-19A536-RA or
equivalent meeting Ford specification WSEM5B292-
A.
2. Lubricate the camshaft journals.
Use Super Premium SAE 5W30 Motor Oil D9AZ-
19579-A or equivalent meeting Ford specification
WSS-M2C153-C.
3. Install the camshaft and the camshaft bearing caps
in their original location and the bolts.
Lubricate and position the camshaft bearing caps.
--Use Super Premium SAE 5W30 Motor Oil
D9AZ-19579-A or equivalent meeting Ford
specification WSS-M2C153-G.
To Next Page
Loading...
