154
WSG-1068 ENGINE
5. Install the retainer plate. Tighten the bolts to 8-12
Nm (71-107 lb/in).
6. Use the Rear Crankshaft Seal Replacer and Rear
Crankshaft Seal Adapter to install the crankshaft rear
oil seal (6701).
7. With the Rear Crankshaft Seal Adapter still installed,
use the Rear Crankshaft Slinger Replacer to install
the crankshaft oil slinger.
8. Install the flywheel (6375).
9. Install the starter motor (11002).
To Next Page
Loading...
