48
WSG-1068 ENGINE
Valve Cover – Left - Installation
1. CAUTION: Mating parts must make contact
to each other within 4 minutes and connecting
bolts must be torqued within 15 minutes after
applying sealant. Failure to follow this procedure
can cause future oil leakage.
Use silicone gasket and sealant F6AZ-19562-AA
or equivalent meeting Ford specification WSEM4G323-A6.
NOTE: Sealant must be removed and area cleaned with
solvent if above instructions are not followed.
Use metal surface cleaner F4AZ-19A536-RA or
equivalent meeting Ford specification WSEM5B292-A.
2. Apply silicone in two places where the engine front
cover (6019) meets the cylinder head.
Use Silicone Gasket and Sealant F6AZ-19562-AA or
equivalent meeting Ford specification WSEM4G323-A6.
3. Position the valve cover and the valve cover gasket
on the cylinder head and loosely install the bolts and nuts.
To Next Page
Loading...
