57
WSG-1068 ENGINE
Front Engine Cover - Removal
1. WARNING: DO NOT SMOKE OR
CARRY LIGHTED TOBACCO OR OPEN FLAME OF
ANY TYPE WHEN WORKING ON OR NEAR ANY
FUEL-RELATED COMPONENTS. HIGHLY
FLAMMABLE MIXTURES ARE ALWAYS PRESENT
AND CAN BE IGNITED, RESULTING IN POSSIBLE
PERSONAL INJURY.
Disconnect the battery ground cable (14301).
2. Remove the valve covers (6582); refer to Valve Cover
in this section.
3. Remove the radiator (8005).
4. Disconnect the camshaft position sensor (CMP
sensor) (6B288).
5. Remove the drive belt (8620).
6. Disconnect the crankshaft position (CKP) sensor
electrical connector.
7. Remove the drain plug and drain the engine oil.
8. Remove the crankshaft front seal (6700); refer to
Crankshaft Front Oil Seal in this section.
9. Remove the bolts from the front of the oil pan that
hold the front cover.
To Next Page
Loading...
