eno one 2/r - user manual
REV.05
34
29. nC (not copy) DOSE PROGRAMMING
Having entered the "F.4 function" and
having chosen "nC" (para. 27) press
the multifunction button (Z).
Flashing of the display lines conrms
successful programming of the set-
ting.
The Dispenser is now awaiting
programming, dened by ashing of
the two points on the display.
Place a glass or a graduated cylinder
under any dispensing nozzle and
press one of the dose dispensing
buttons (V) until the desired volume
of liquid is obtained.
If the rst pressing lasts less than
half a second, the dose will not be
perceived and an error will be re-
ported with rapid ashing of all the
light buttons.
In the next 5 seconds, if the dis-
pensed volume is insufcient, it
is possible to increase it either by
pressing once more or with short se-
quential pressings.
After 5 seconds from the last
dosing, the Dispenser will recognise
the dose and will prepare for the next
one. The button relating to the dose
just stored is now switched off.
Repeat the same operation for the
5 remaining buttons. Having pro-
grammed all the doses, the Dispens-
er places itself automatically in oper-
ating mode.
To Next Page
Loading...