Enterasys SecureStack B2 B2G124-48P - Switch Configuration Using Webview; Switch Configuration Using CLI Commands; Standards Compatibility

Standards Compatibility
SecureStack B2 Installation Guide 1-7
Switch Configuration Using WebView
Enterasys N etworks’HTTP‐basedWebmanagementapplication(WebView)isan
intuitivewebtoolforsimplemanagementtasks.
Switch Configuration Using CLI Commands
TheCLIcommandsenableyoutoperformmorecompleteswitchconfiguration
managementtasks.
ForCLIcommandsetinformationandhowtoconfigurethemodule,refertothe
SecureStackB2ConfigurationGuide.
Standards Compatibility
The1000BASE‐Tportsarecompliantwiththefollowingstandardsandoperations:
• IEEE802.3
• IEEE802.3u
• IEEE802.3ab
•Full‐Duplexoperation
TheSFPportsarecompliantwiththefollowingstandardsandoperations:
• IEEE802.3z
• IEEE802.3xFlowControlsupportforFull‐Duplexmode
•Auto‐negotiationforFull‐Duplexcontroloperation
Thestackingportprovides
20GbpsperportconnectedtoMemberswitchesforupand
downlinkconnections.