Enterasys SecureStack B2 B2G124-48P - Using the Reset Switch

Using the Reset Switch
SecureStack B2 Installation Guide 4-9
Using the Reset Switch
Ifyouforgettheswitchloginpassword,usetheResetswitchasdescribedinthef ollowing
procedure.
Figure 4-24 Reset Switch
Toresettheswitchpassword,referbacktoFigure 4‐24andproceedasfollows:
1. Press‐and‐holdtheResetswitchwhilethe switchdeviceisoperational.Thischangeof
theloginpasswordtothe
defaultpasswordwillbeindicatedthroughCLIonly.
2. Logontodevicemanagement.YoucannowlogontotheswitchthroughtheConsole
portandassignanewpasswordusingthecommandlineinterface(CLI).
3. ToaccessswitchmanagementfromyourlocalPC,terminal,ormodemconnection,
refertotheSecureStackB2
ConfigurationGuideforinstructionsonhowtologinand
enteranewpassword.Theguideisavailab le at:
http://www.enterasys.com/support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in“GettingHelp”onpage 1‐8.
1 Reset switch
Note: Notify the system manager before changing the password.
STACK UP
STACK DOWN
À