Enterasys SecureStack B2 B2G124-48P - Chapter 4: Troubleshooting; Using LANVIEW

SecureStack B2 Installation Guide 4-1
4
Troubleshooting
Thischapterprovidesinformation concerningthefollowing:
Thisdevicecontainsabattery tha tisnotconsideredauserreplaceablepart.Ifthebattery
needstobereplaced,contactcustomerserviceforrepair.
Using LANVIEW
TheswitchusestheEnterasys Networksbuilt‐invisualdiagnosticandstatusmonitoring
systemcalledLANVIEW.ForthelocationofLANVIEWLEDsontheB2G124‐48Pand
B2H124‐48P,refertoFigure 4‐22andFigure 4‐23,respectively.TheseLEDsallowyouto
quicklyobservenetwork statusfordiagnosingswitchandnetwork
problems.
For information about... Refer to page...
Using LANVIEW 4-1
Troubleshooting Checklist 4-7
Using the Reset Switch 4-9
Caution: There is a risk of explosion if the battery is replaced with an incorrect type. A
used battery may be safely disposed in a municipal waste stream.
Precaucion: Hay riesgo de explosion si la bateria se reemplaza con el typo incorrecto.
Puede tirar la bateria usada en la basura