Enterasys SecureStack C2 C2G124-24 - Management; Switch Configuration Using Webview; Switch Configuration Using CLI Commands; Standards Compatibility

Management
1-6 Introduction
Management
Managementofthemodulecanbeeitherin‐bandorout‐of‐band.In‐bandremote
managementispossibleusingTelnet,EnterasysNetworks’NetSight
®
management
application,ortheWebViewapplication.Out‐of‐bandmanagementisprovidedthrough
theRJ45COM(Communication)portonthefrontpanelusingaVT100terminalora
VT100terminalemulator.
Switch Configuration Using WebView
EnterasysNetworks’HTTP‐basedWebmanagementapplication(WebView)isan
intuitivewebtoolforsimplemanagementtasks.
Switch Configuration Using CLI Commands
TheCLIcommandsenableyoutoperformmorecompleteswitchconfiguration
managementtasks.
ForCLIcommandsetinformationandhowtoconfigurethemodule,refertothe
SecureStackC2ConfigurationGuide.
Standards Compatibility
TheswitchesarefullycompliantwiththeIEEE802.3‐2002,802.3ae‐2002,802.1D ‐1998,and
802.1Q‐1998standards.TheswitchesprovideIEEE802.1D‐1998SpanningTreeAlgorithm
(STA)supporttoenhancetheoverallreliabilityofthenetworkandprotectagainst“loop”
conditions.
LANVIEW Diagnostic LEDs
LANVIEWdiagnosticLEDsserveasanimportanttroubleshootingaidbyprovidingan
easywaytoobservethestatusofindividualportsandoverallnetworkoperations.
MGBIC-08 Provides one 1000BASE-ELX compliant LC fiber-optic single-mode port with a
standard LC connector. For optical and operating range specifications, refer to
“MGBIC-08 Specifications (1000BASE-ELX)” on page A-7.
MGBIC-02 Provides one 1000BASE-T compliant copper port with an RJ45 connector. For
port specifications, refer to “MGBIC-02 Specifications (1000BASE-T)” on
page A-7.
Table 1-1 Description of Mini-GBICs (Continued)
Mini-GBIC Specification