Enterasys SecureStack C2 C2G124-24 - Configuring Switches in a Stack

Configuring Switches in a Stack
3-12 Hardware Installation
Figure 3-7 High-Speed Stacking Cable Connections
Afterconnectingthecablestothestackingports,proceedto “ConfiguringSwitchesina
Stack”onpage 3‐12forinstructions.
Configuring Switches in a Stack
TheinformationinthefollowingsectionsisimportanttounderstandSecureStackC2
switchoperationandinstallationsinastackinstallation.
About SecureStack C2 Switch Operation in a Stack
TheSecureStackC2productsarestackableswitchesthatcanbeadaptedandscaledto
helpmeetyournetworkneeds.Theseswitchesprovideamanagementplatformand
uplinktoanetworkbackboneforastackedgroupofuptoeightC2swit ches.
1 High-speed stacking cable 4 STACK DOWN connector at top of stack
2 STACK DOWN connector 5 STACK UP connector at bottom of stack
3 STACK UP connector
Redundant Power Supply
AC LINE
100-240 VAC
50-60 Hz
0.8 A MAX
MAC ADDRESS SERIAL NO.
STACK UP STACK DOWN
Redundant Power Supply
AC LINE
100-240 VAC
50-60 Hz
0.8 A MAX
MAC ADDRESS SERIAL NO.
STACK UP STACK DOWN
Redundant Power Supply
AC LINE
100-240 VAC
50-60 Hz
0.8 A MAX
MAC ADDRESS SERIAL NO.
STACK UP STACK DOWN
Redundant Power Supply
AC LINE
100-240 VAC
50-60 Hz
0.8 A MAX
MAC ADDRESS SERIAL NO.
STACK UP STACK DOWN
Â
À
À
À
À
Â
Â
Ä
Ã
Ä
Á
Á
Á
Â
Â
Â