Enterasys SecureStack C2 C2G124-24 - Connecting to a Modem

Connecting to Console Port for Local Management
SecureStack C2 Installation Guide 3-21
Connecting to a Modem
ToconnectamodemtoanEnterasys Networksswitchmodemport(Figure 3‐12),usea
UTPcableterminatedwithaDB9femaleconnectorandaDB25maleconnector,and
proceedasfollows:
1. ConnecttheDB9femaleconnectoratoneendofthecabletotheConsoleportonthe
Enterasysswitch.
(IfthereisaswitchdesignatedastheManager,connecttoits
Consoleport.)
2. PlugtheDB25maleconnectorattheotherendofthecableintothe modem
communicationsport.
3. TurnonthemodemandmakesuretheremotemodemisON.
4. WithyourPCconnectedtotheremotemodem,configure
yourVTemulationpackage
withthefollowingparameters:
Whentheseparametersareset,theStartupscreenwilldisplay.Iftheswitchesareina
stackedconfiguration,proceedto“ConnectingtotheNetwork”onpage 3‐22.
Figure 3-12 Connecting to a Modem
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
1 DB9 female cable connector 4 DB25 male connector 7 PC with VT emulation application
2 Serial interface cable 5 Local modem
3 DB9 male Console port 6 Remote modem
ÂÃ Á À ÄÅÆ
Console
C
P
U
U
P
R
P
S
M
G
R
D
O
W
N