Enterasys SecureStack C2 C2G124-24 - Using the Reset Button

To Next Page

To Previous Page

Troubleshooting Checklist

4-8 Troubleshooting

Using the Reset Button

Ifyouforgettheswitchloginpassword,usetheResetbuttonasdescribedinthefollowing

procedure.

Figure 4-4 Reset Button

Toresettheswitchpassword,refertoFigure 4‐4andproceedasfollows:

1. Press‐and‐holdtheReset bu tton whiletheswitchisoperational.Thischangeofthe

willbeindicatedviaCLIonly.

2. Logontodevicemanagement.Youcannowlogontotheswitchviathe Consoleport

andassignanewpasswordusingthecommandlineinterface(CLI).

3. ToaccessswitchmanagementfromyourlocalPC,terminal,ormodemconnection,

refertotheSecureStackC2ConfigurationGuide

forinstructionsonhowtologinand

enteranewpassword.Theguideisavailab le onlineundertheCcategoryat:

http://www.enterasys.com/support/manuals

Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed

in“GettingHelp”onpage 1‐7.

1 Reset button

Note: Notify the system manager before changing the password.

STACK UP

STACK DOWN

Related product manuals