eove EO-70 - Attaching a Control Pedal; Upright Bracket Installation for a Vertical Position of the Device

35
Attaching a control pedal
1. Connect the plug of the remote-control connector at the rear of the device.
CAUTION
To
remove the cable, pull firmly on the locking ring. Do not twist.
Upright Bracket installation for a vertical position of the device
1. Insert the upright brackets into the guides located on the lower housing of the device.
NOTE:
Upright
brackets are fully reversible and can be used on the right or left guide with th
e
same feature
Locking Ring