2-20
Printing on Continuous Paper
R4C4620
Rev. C
A5 size CONT.FM
6/14/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara T.Takahashi
T.Takahashi
SEI M.Kauppi K.Blair
14. Remove any slack in the paper and adjust the top-of-form
position (the position where the printer will start printing) by
pressing the
LF/FF
button or using the micro adjust feature.
(To use the micro adjust feature, see “Adjusting the Top-of-
Form Position” on page 2-31.) The printer will start printing
at the current position without advancing the paper.
c
Caution:
❏
Never use the knob to remove slack in the paper or to
adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.
❏
Always remove any slack from the paper; otherwise print
quality may be reduced.
15. Attach the printer cover and close the paper guide cover.
16. You may need to check and change the printer driver settings
as described in Chapter 4. Then send a print job to the printer.
The printer starts printing from the current position without
advancing the paper. The printed pages are fed over the paper
guide toward the back of the printer.
To Next Page
Loading...
