1 - 18
Chapter 1 Troubleshooting
Epson AcuLaser C2900N
Revision B
Confidential
077
102
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit On JAM>
The paper does not reach the Exit Sensor within the specified
time.
FIP-1.39
103
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit On early JAM>
The paper remains at the paper transfer path between the Exit
Sensor and the Regi Sensor.
FIP-1.39
104
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit Off JAM>
The paper does not pass through the Exit Sensor within the
specified time.
FIP-1.40
105
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit Off early JAM>
The paper passed through the Exit Sensor earlier than the
specified time.
FIP-1.40
106
Jam at Front
Cover
Open Front Cover
and Remove Paper
<IOT Stop Reservation JAM>
Detect jam when stopped before fuser unit in forced stop
mode.
FIP-1.39
107
Jam at Duplexer
Open Front Cover
Lift Duplexer
<IOT Duplex Misfeed JAM>
In the duplex printing mode, the lead edge does not reach the
Regi Sensor when the sheet changes the direction in the
Duplexer after the standby.
FIP-1.41
108
Jam at Duplexer
Open Front Cover
Lift Duplexer
<IOT Duplex JAM>
In the duplex printing mode, the lead edge does not reach the
SSI No Paper Sensor when the sheet changes the direction in
the Duplexer after the standby.
FIP-1.41
215
Duplexer Error
Restart Printer
Error 077-215
Restart Printer
<IOT Duplexer Failure>
The error is detected by Duplexer communication check.
FIP-1.42
300
Front Cover Open
Close FrontCover
<IOT Cover Front Open>
The Front Cover is open.
FIP-1.43
301
Side Door Open
Close Side Door
<IOT Side Cover Open>
The Toner Access Cover is open.
FIP-1.44
900
Jam at Exit
Open Front Cover
and Remove Paper
<IOT Exit JAM>
The paper remains at the Exit Sensor.
FIP-1.45
901
Jam at Front
Cover
Open Front Cover
and Remove Paper
<IOT Remain Registration JAM>
The paper remains at the Regi Sensor.
FIP-1.46
907
Jam at Duplexer
Open Front Cover
Lift Duplexer
<IOT Remain Duplex JAM>
The paper remains at the Duplex area.
FIP-1.47
Status
Code
Error Message
Status Contents
FIP to be
referred
LCD
To Next Page
Loading...
