Epson Artison 800 - Page 204

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Routing FFC/cables 205
Confidential
CARD SLOT ASSY
Note * :See Fig. 4-245 for the connector positions on the Main Board.
Figure 4-249. Card Slot Assy (1)
Figure 4-250. Card Slot Assy (2)
No. FFC/cable name CN No.
*
Remarks
1 I/F FFC (Infra-red) CN32
Mounted only in Japanese
models.
2 SUB FFC CN7 ---
3 STG FFC CN31 Ferrite Core x2
STG FFC:
Fold this back to the front of the Card Slot
Assy and secure it with acetate tape.
Front side of the
Card Slot Assy
Double-sided tape
Fold line
Fold
Bottom of the
Card Slot Assy
SUB FFC
I/F FFC (Mounted only in Japanese
models.):Secure this with acetate tape on the
bottom of the Card Slot Assy.
Acetate tape
STG FFC
Double-
sided tape
Main Board Unit
Ferrite Core Holder A
After installation
Fold
STG FFC
Put the FFC
through the
Ferrite Core
Holder A after
folding it back
Before installation
Ferrite Core
Ferrite Core Holder A
Double-sided tape
Fold line
I/F FFC (Mounted only in
Japanese models.):Route
this between SUB FFC
and Base Frame.
SUB FFC:
Route this between Ferrite Core and Base Frame, and
secure it to the Main Board Unit with double-sided tape
STG FFC:
Insert ferrite core on STG FFC into Base Frame,
and put the FFC through Ferrite Core Holder A,
then attach them to the Main Board Unit.
http://www.manuals4you.com