Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Routing FFC/cables 208
Confidential
Note * :See Fig. 4-245 for the connector positions on the Main Board.
Figure 4-255. PF Motor Cable, Power Supply Unit Cable
Note " * " : See Fig. 4-245 for the connector positions on the Main Board.
Figure 4-256. PE Sensor Cable
No. FFC/cable name CN No.
*
Remarks
1 PF Motor Cable CN22 Ferrite Core x1
2 Power Supply Unit cable CN501 ---
Power Unit cable:
Route this through the hooks (x5)
and secure it with acetate tape.
Hook securing PF Motor cable
Hook securing Power Supply Unit cable
Groove
PF Motor cable:
Route through the hooks (x5)
and secure with the acetate tape.
Acetate tape
Views without the CDR
Power Supply Unit cable:
Route this through the groove on Base Frame.
PF Motor cable:
Place the relay connector to the hole on
Base Frame, and route the cable through
the hooks (x3) and the groove (x1).
Relay Connector
Do not let this
get caught.
Right
side
No. FFC/cable name CN No.
*
Remarks
1 PE Sensor Cable CN9 Ferrite Core x1
Transmission Holder Assy
To the dowel of Base Frame
PE Sensor cable:
Route this through the grooves (x3)
of Transmission Holder Assy.
To PE Sensor
To Transmission Holder Assy
Groove
Dowel
To Main Board
Ferrite core
PE Sensor cable:
Route this through the dowels, and
attach ferrite core into Base Frame.
http://www.manuals4you.com
To Next Page
Loading...
