Epson Artison 800 - Page 236

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
ADJUSTMENT Adjustment without Using Adjustment Program 237
Confidential
• The EJ Frame Assy must be lowered most.
Figure 5-35. Position of EJ Frame Assy
• Check that the PG cams; located on both the left side and the right side of the
Carriage Shaft and the CR guide plate, are in the PG-position.
( Fig. 5-36 )
Figure 5-36. PG position when adjusting
 Adjustment procedure
1. Move the carriage to the home position.
2. Loosen all the screws the secure each parallelism adjustment bushing. ( Fig. 5-34 )
3. Attach the parallelism adjustment jigs to the printer mechanism.
Figure 5-37. Installing the parallelism adjustment jigs
80 column side
0 column side
Confirm they are set here.
Right side
Left side
Place the rear of Jig on
Carriage Shaft.
A
B
C
D
Place the front of Jig on CR
Guide Plate.
C
D
Place Jig aligning the bits with the ribs shown above.
A
B
Place Jig aligning the bits with the ribs shown above.
Location of the bits of dial gauge (C) (D)
Location of the bits of dial gauge (A) (B)
http://www.manuals4you.com