Epson CMOS 32-Bit Single Chip Microcomputer S1C33L03 - PLL Characteristics

8 ELECTRICAL CHARACTERISTICS
A-108 EPSON S1C33L03 PRODUCT PART
OSC3 ceramic oscillation
(Unless otherwise specified: VSS=0V, Ta=25°C)
Item Symbol Condition Min. Typ. Max. Unit ∗
Oscillation start time tSTA3 10MHz ceramic oscillator 10 ms 1
16MHz ceramic oscillator 10 ms 2
20MHz ceramic oscillator 10 ms 3
25MHz ceramic oscillator 5 ms 4
33MHz ceramic oscillator 5 ms 5
∗ note) No. Ceramic Recommended constants Power voltage Remarks
oscillator CG2 (pF) CD2 (pF) Rf2 (MΩ)range (V) (Manufacturer)
1CST10.0MTW 30 3011.8 to 2.2 (Murata Mfg. corporation) ∗1
2CST16.00MXW0C1 5 5 1 1.8 to 2.2 (Murata Mfg. corporation)
3CST20.00MXW0H1 5 5 1 1.8 to 2.2 (Murata Mfg. corporation)
4CST25.00MXW0H1 5 5 1 2.7 to 3.6 (Murata Mfg. corporation)
5CST33.00MXZ040 Open Open 1 2.7 to 3.6 (Murata Mfg. corporation)
∗1This oscillator has a tendency to rise to the frequency of 0.3%.
8.8 PLL Characteristics
Setting the PLLS0 and PLLS1 pins (recommended operating condition)
VDD=2.7V to 3.6V
PLLS1 PLLS0 Mode Fin (OSC3 clock) Fout
11x210 to 25MHz 20 to 50MHz
01x410 to 12.5MHz 40 to 50MHz
00PLL not used – –
VDD=2.0V±0.2V
PLLS1 PLLS0 Mode Fin (OSC3 clock) Fout
11x210MHz20MHz
00PLL not used – –
PLL characteristics
(Unless otherwise specified: VDD=2.7V to 3.6V, VSS=0V, crystal oscillator=Q3204DC
#
1
,
R
1=4.7kΩ, C1=100pF, C2=5pF, Ta=-40°C to +85°C)
Item Symbol Condition Min. Typ. Max. Unit ∗
Jitter (peak jitter) tpj -1 1 ns
Lockup time tpll 1 ms
#1 Q3204DC: Crystal oscillator made by Seiko Epson
(Unless otherwise specified: V
DD=2.0V±0.2V, VSS=0V, crystal oscillator=Q3204DC
#
1
,
R
1=4.7kΩ, C1=100pF, C2=5pF, Ta=-40°C to +85°C)
Item Symbol Condition Min. Typ. Max. Unit ∗
Jitter (peak jitter) tpj -2 2 ns
Lockup time tpll 2 ms
#1 Q3204DC: Crystal oscillator made by Seiko Epson