Epson CMOS 32-Bit Single Chip Microcomputer S1C33L03 User Manual

VI SDRAM CONTROLLER BLOCK: SDRAM INTERFACE
B-VI-2-16 EPSON S1C33L03 FUNCTION PART
Figure 2.12 shows an example of a timing chart in cases where the row address is varied during burst read.
BCLK
Command
SDCKE
#SDCEx
#SDRAS
#SDCAS
#SDWE
SDBA[1:0]
SDA[10]
SDA[12:11, 9:0]
LDQM/HDQM
DQ[15:0]
ACTVNOP
H
NOP NOP NOPPRE NOP READ
BA BA
ROW1
D (n) D (n+1) D (n+2) D (0) D (1) D (2)
tRCDtRP tRCD
tRAS
tRPCAS latency
= 2
CAS latency
= 2
ROW1 COLn
BA
ACTV NOPPRE NOP READ
BA BA
ROW2
ROW2 COL0
BA
Figure 2.12 Changing Row Address During Burst Read
Single Read/Single Write
If the burst length is set to "1" (SDRBL[1:0] = "00"), the SDRAM controller reads data from the SDRAM in a
single operation.
When writing to the SDRAM, data are always written in a single operation, no matter what burst length is selected.
BCLK
Command
SDCKE
#SDCEx
#SDRAS
#SDCAS
#SDWE
SDBA[1:0]
SDA[10]
SDA[12:11, 9:0]
LDQM/HDQM
DQ[15:0]
ACTVNOP
H
NOP NOPPRE NOP READ
BA1 BA1
ROW1
D(1)
tRCDtRP tRCDtRPCAS latency
= 2
ROW1 COL1
BA1
ACTV NOPPRE NOP
BA2 BA2
ROW2
ROW2 COL2
BA2
D(2)
WRIT
Figure 2.13 Single Read to Single Write (different page)
BCLK
Command
SDCKE
#SDCEx
#SDRAS
#SDCAS
#SDWE
SDBA[1:0]
SDA[10]
SDA[12:11, 9:0]
LDQM/HDQM
DQ[15:0]
ACTVNOP
H
NOP NOP NOPPRE NOP READ
BA BA
ROW1
D(n) D(n+1) D(n+2) D(m)
tRCDtRP CAS latency
= 2
ROW1 COLn
BA
WRIT NOP PRE
BA
COLm
BA
Figure 2.14 Burst Read to Single Write (same page)

Epson CMOS 32-Bit Single Chip Microcomputer S1C33L03 Specifications

General

Brand	Epson
Model	CMOS 32-Bit Single Chip Microcomputer S1C33L03
Category	Computer Hardware
Language	English