III PERIPHERAL BLOCK: SERIAL INTERFACE
B-III-8-20 EPSON S1C33L03 FUNCTION PART
•Overrun error
If during successive receive operations, a receive operation for the next data is completed before the receive
data register is read out, the receive data register is overwritten with the new data. Therefore, the receive data
register must always be read out before a receive operation for the next data is completed.
When the receive data register is overwritten, an overrun error is generated and the overrun-error flag is set to
"1".
Ch.0 overrun-error flag: OER0 (D2) / Serial I/F Ch.0 status register (0x401E2)
Ch.1 overrun-error flag: OER1 (D2) / Serial I/F Ch.1 status register (0x401E7)
Ch.2 overrun-error flag: OER2 (D2) / Serial I/F Ch.2 status register (0x401F2)
Ch.3 overrun-error flag: OER3 (D2) / Serial I/F Ch.3 status register (0x401F7)
Even when this error occurs, the received data in error is transferred to the receive data register and the
receive operation is continued.
The OERx flag is reset to "0" by writing "0".
(4) Terminating receive operation
When a data receive operation is completed, write "0" to the receive-enable bit RXENx to disable receive
operations.
To Next Page
Loading...
