Image Shape
37
You can project an even, rectangular image by placing the projector directly
in front of the center of the screen and keeping it level. If you place the
projector at an angle to the screen, or tilt it up or down, or off to the side, you
may need to correct the image shape.
After correction, your image is slightly smaller.
For the best quality images, we recommend adjusting the installation position
of the projector to achieve the correct image size and shape.
gg Related Links
• "Correcting the Image Shape with the Keystone Button" p.37
• "Correcting the Image Shape with Quick Corner" p.38
Correcting the Image Shape with the Keystone
Button
You can correct the shape of an image that is unevenly rectangular.
To correct the distortion in the horizontal and vertical directions
independently, use the button on the remote control.
a
• You cannot combine H/V-Keystone correction with other image
shape correction methods.
• You can correct keystone distortion by up to 30º right, left, up, or
down.
a
Turn on the projector and display an image.
b
Press the button on the remote control, select H/V-Keystone, and
then press [Enter].
You see the Keystone adjustment screen:
c
Use the arrow buttons on the remote control to select between vertical
and horizontal keystone correction and to adjust the image shape as
necessary.
• V-Keystone
• H-Keystone
d
When you are finished, press .
After correction, your image is slightly smaller.
To Next Page
Loading...
