Turning On the Projector
28
Warning
• Never look into the projector lens when the lamp is on. This can damage your
eyes and is especially dangerous for children.
• When turning on the projector at a distance using the remote control, make sure
there is no one looking into the lens.
• During projection, do not touch the projector. The high heat generated by the
projector lamp may cause a burn or injury.
• During projection, do not block the light from the projector with a book or other
objects. If the light from the projector is blocked, the area on which the light
shines becomes hot which could cause it to melt, burn, or start a fire. Also, the
lens may get hot due to the reflected light which could cause the projector to
malfunction. To stop projection, use the A/V Mute function, or turn off the
projector.
• A mercury lamp with high internal pressure is used as the projector's light
source. If the lamp is subjected to vibrations or shocks, or if it is used for an
overly extended length of time, the lamp may break or it may not turn on. If the
lamp explodes, gases may escape and small fragments of glass may be scattered
which could cause an injury. Be sure to observe the instructions below.
• Do not bring your face close to the projector while it is in use.
• Do not swing or tilt the projector. Shards of glass may fall out and could cause
an injury. Be very careful not to allow such pieces of glass to enter your eyes or
mouth.
• If the lamp breaks, ventilate the area immediately, and contact a doctor if any
fragments of broken glass are inhaled or get into the eyes or mouth.
• Do not turn the projector back on immediately after turning off the projector.
Turning the projector on/off too frequently can shorten the lamp life.
a
• When the Direct Power On setting is set to On in the projector's
Settings menu, the projector turns on as soon as you plug it in. Note
that the projector also turns on automatically in cases such as
recovery from a power outage.
s Settings > Operation > Direct Power On
• If you select a specific port as the Auto Power On setting in the
projector's Settings menu, the projector turns on as soon as it detects
a signal or cable connection from that port.
s Settings > Operation > Auto Power On
gg Related Links
• "Home Screen" p.28
• "Projector Feature Settings - Settings Menu" p.81
Home Screen
The Home screen feature allows you to easily select an image source and
access useful functions. You can display the Home screen by pressing the
button on the remote control. The Home screen is also displayed when you
turn on the projector and no signal is being input.
Press the arrow buttons on the remote control to select a menu item, and then
press [Enter].
A
Selects the source you want to project.
B
Displays the Connection Guide. You can select the wireless connection methods
according to the devices you are using, such as smartphones or computers.
C
Displays the Help screen.
To Next Page
Loading...
Need help?
General