Selecting an Image Source
43
When multiple image sources are connected to the projector, you can switch
from one image source to the other.
a
Make sure the connected image source you want to use is turned on.
b
For video image sources, insert a DVD or other video media and press
play.
c
Do one of the following:
• Press the button on the remote control until you see the image
from the source you want.
a
This screen is displayed when no image signal is detected.
Check the cable connections between the projector and image
source.
• Press the button on the remote control.
Then select the source you want to use from the screen displayed.
a
When no image signal is detected, check the cable connections
between the projector and the image source.
To Next Page
Loading...
Need help?
General