Saving a User's Logo Image
62
You can save an image on the projector and display it whenever the projector
turns on. You can also display the image when the projector is not receiving
an input signal. This image is called the user's logo screen.
You can select a photo, graphic, or company logo as the user's logo, which is
useful in identifying the projector's owner to help deter theft. You can prevent
changes to the user's logo by setting up password protection.
a
• If User's Logo Protection in the Password Protection setting is set
to On, set to Off before saving the user's logo.
• When you copy the menu settings from one projector to another
using the batch setup feature, user's logo is also copied. Do not
register the information that you do not want to share between
multiple projectors as a user's logo.
• You cannot save content that is protected by HDCP.
a
Display the image you want to project as the user's logo.
b
Press the button on the remote control.
c
Select the Settings menu and press [Enter].
d
Select Display > User's Logo > Start Setting, and press [Enter].
You see a prompt asking if you want to use the displayed image as a
user's logo.
a
Adjustments such as Keystone, Zoom, or Aspect are temporarily
canceled when you select User's Logo.
e
Select Yes and press [Enter].
f
Check the displayed image, and then select Yes to save it as the user's
logo.
The user's logo is overwritten and a completion message is displayed.
g
Press to exit the message screen.
h
Select when you want to display the User's Logo screen:
• To display it whenever there is no input signal, select Display
Background and set it to Logo.
• To display it whenever you turn the projector on, select Startup
Screen and set it to On.
To Next Page
Loading...
Need help?
General