74
Disc drop error The arm dropped the disc while transferring it.
Remove the dropped disc, turn off the power, and then turn
on the power again.
Disc feed error
DRV 1/2
The disc was not transferred properly to the drive.
Perform the procedure below.
1. Remove the discs from the drive tray.
2. Fully separate and reload the discs in the input stacker.
3. Close the disc cover.
Disc feed error
PRN
The disc was not transferred properly to the printer.
Perform the procedure below.
1. Remove the discs from the printer tray.
2. Fully separate and reload the discs in the input stacker.
3. Close the disc cover.
Disc is
not writable
Processing of the job is paused.
Perform the procedure below.
1. Open the disc cover.
2. Remove the disc that cannot be written or the disc that is
already written from the input stacker (Stacker 1 or Stacker
2).
3. Load a disc that can be written. (See “Writable Disc Types”
in the PP-100N User’s Guide.)
4. Close the disc cover.
Processing of the job is automatically resumed.
Disc is
wrong type
Processing of the job is paused. Perform the procedure
below.
1. Open the disc cover.
2. Remove the disc from the input stacker (Stacker 1 or
Stacker 2) that is a different type from the disc type that was
set.
3. Load the correct disc type. (See “Disc Loading” in the PP-
100N User’s Guide.)
4. Close the disc cover.
Processing of the job is automatically resumed.
Disc pickup
error (DRV 1/2)
The disc in the drive tray cannot be picked up. Turn off the
power, and then turn it on again. If the same error message
still appears, repair is required. Please contact Customer
Support.
Disc pickup
error (PRN)
The disc in the printer tray cannot be picked up. Turn off the
power, and then turn it on again. If the same error message
still appears, repair is required. Please contact Customer
Support.
Error Message Remedy
Notification
Sound
To Next Page
Loading...
Need help?
General
Weight and Dimensions
