Name Function
B
A/V mute slide knob
Slide the knob to open and close the A/V mute slide.
By closing the A/V mute slide during projection you can
hide the image and the sound.
s "Hiding the Image and Sound Temporarily (A/V
Mute)" p.45
C
Polarizer
Used for viewing 3D images.
See the following manual for more information on
attaching the polarizer.
s Startup Guide
D
Front adjustable foot
When setup on a surface such as a desk, extend the foot to
adjust the position of the image.
s "Adjusting the Image Position" p.36
E
Remote receiver
Receives signals from the remote control.
F
Sensor
This sensor allows two images to be placed on top of each
other.
G
Focus ring
Adjusts the image focus.
s "Correcting the Focus" p.37
H
Zoom ring
Adjusts the image size.
s "Adjusting the Image Size" p.36
I
Indicators
Indicates the projector's status.
s "Reading the Indicators" p.67
J
Control panel
Operates the projector.
s "Control Panel" p.13
K
Lamp cover
Open when replacing the projector's lamp.
s "Replacing the Lamp" p.84
Side
The following example uses the commander. The receiver performs the
same operations.
Name Function
A
Stacker angle
adjustment section
Adjusts the commander's projection angle according
to the projection distance.
s Startup Guide
B
Stacker mount
connector
Connects the mount and the screws hold it in place.
s Startup Guide
C
Security cable
installation point
Pass a commercially available wire lock through here
and lock it in place.
s
"Installing the wire lock" p.52
D
Security slot
The security slot is compatible with the Microsaver
Security System manufactured by Kensington.
s "Anti-Theft Lock" p.52
E
Speaker
Outputs audio.
F
Air filter cover
section
Place your finger to open the air filter cover.
s "Replacing the Air Filter" p.88
G
Air intake vent
(air filter)
Takes in air to cool the projector internally.
s "Cleaning the Air Filter" p.83
Part Names and Functions
10
To Next Page
Loading...
