Name Function
B
Rear feet
When setup on a surface such as a desk, turn to extend and
retract to adjust the horizontal tilt.
s "Adjusting the Horizontal Tilt" p.36
See the following manual for more information on
attaching the rear feet.
s Startup Guide
C
Security cable
installation point
Pass a commercially available wire lock through here and
lock it in place.
s "Installing the wire lock" p.52
D
Front adjustable foot
When setup on a surface such as a desk, extend the foot to
adjust the position of the image.
s "Adjusting the Image Position" p.36
See the following manual for more information on
attaching the front foot.
s Startup Guide
Control Panel
You can perform projector operations from the commander's control panel.
The receiver's control panel cannot be used while projecting in a stacked
configuration.
Name Function
A
[t] button
Turns the projector power on or off.
s "From Installation to Projection" p.32
B
[Source Search]
button
Changes to the next input source that is sending an image.
s "Automatically Detect Input Signals and Change the
Projected Image (Source Search)" p.34
Part Names and Functions
13
To Next Page
