Images are fuzzy, out of focus, or distorted
Check Remedy
Are the images from the commander and the receiver superimposed
correctly?
Press the [Screen Fit] button. The adjustment screen is displayed and the images are superimposed correctly after a few
seconds.
See the following manual when superimposing images for the first time after installation.
s Startup Guide
Is Auto Setup set to Off? When set to On, Tracking, Sync., and Position are automatically optimized.
s Signal - Auto Setup p.58
Is the projector at the correct distance? Is it projecting outside of the recommended projection distance range?
Setup within the recommended range.
s "Screen Size and Projection Distance" p.96
Has condensation formed on the lens? If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient temperature
changes occur, condensation may form on the surface of the lens, and this may cause the images to appear fuzzy. Set the
projector up in the room about one hour before it is used. If condensation forms on the lens, turn the projector off and
wait for the condensation to disappear.
Interference or distortion appear in images
Check Remedy
Is the image signal format setting correct?
(Only when projecting images from a video source)
Change the setting according to the signal for the connected equipment.
s Signal - Video Signal p.58
Are the cables connected correctly? Check that all the cables required for projection are securely connected.
s "Connecting Equipment" p.21
Is an extension cable being used? If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the projector to
check if the cables you are using may be causing the problem.
Is the correct resolution selected?
(Only when projecting computer images)
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.98
s Computer's documentation
Are the
Sync.
g
and Tracking
g
settings adjusted correctly?
(Only when projecting computer images)
Press the [Auto] button on the remote control or the [
] button on the control panel to perform automatic adjustment.
Problem Solving
75
To Next Page
Loading...
