You can use only one of the projectors if one of them has malfunctioned or
if you do not need to use two projectors.
Turning On One Projector in a Stacked
Configuration
Turning on only the commander
While holding down the [1] button on the remote control, press the [t]
button.
The commander turns on. The commander can now be used in the same
way as shown in the following EB-W16 manual.
s
EB-W16/EH-TW550/EH-TW510 User's Guide
a
The following functions are not supported.
x Viewing 3D images
x Projecting devices connected to the USB(TypeA) and USB(TypeB)
ports
x Auto H/V-Keystone
x Focus help
x Screen Fit
Turning on only the receiver
While holding down the [2] button on the remote control, press the [
t
]
button. You can also press the [
t] button on the receiver's control panel.
The receiver turns on. The receiver can now be used in the same way as
shown in the following EB-W16 manual.
s EB-W16/EH-TW550/EH-TW510 User's Guide
a
The following functions are not supported.
x Viewing 3D images
x Projecting devices connected to the USB(TypeA) and USB(TypeB)
ports
x Auto H/V-Keystone
x Focus help
x Screen Fit
Clearing the Stacked Configuration and Using One
Projector
a
Turn on the projector (commander and receiver).
a
If the stacked configuration has already been cleared, the
commander and receiver are not linked together and need to be
turned on individually.
x Commander: While holding down the [1] button on the
remote control, press the [t] button.
x Receiver: While holding down the [2] button on the remote
control, press the [
t
] button. You can also press the [
t
]
button on the receiver's control panel.
b
Set Stack Mode to Off from the Configuration menu.
s
Extended - Operation - Stack Mode p.61
c
Press the [t] button on the commander and the receiver to turn
them off.
d
Disconnect the USB cable and the power cables from the
commander or the receiver.
Clearing Stack Mode and then Using a Projector
91
To Next Page
Loading...
