From Installation to Projection
This section explains the procedure for connecting the projectors to a
computer with the computer cable and projecting images.
Follow the steps in the manual below to setup the commander and receiver
in a stacked configuration.
s Startup Guide
a
When setup on a surface such as a desk, the projector on top is the
commander, and the projector on the bottom is the receiver. When
suspended from a ceiling, the projector on top is the receiver, and the
projector on the bottom is the commander.
a
Connect the projectors (commander and receiver) to an electrical
outlet with the power cords.
b
Connect the commander's USB(TypeA) port to the receiver's
USB(TypeB) port with a USB cable.
c
Connect the splitter to the computer's display output port with a
computer cable.
Projecting Images
32
To Next Page
Loading...
