Remote Control
Name Function
A
[t] button
Turns the projector power on or off.
s "From Installation to Projection" p.32
B
[Computer] button
Changes to images from the Computer port.
C
[Video] button
Each time the button is pressed, the image cycles through
the S-Video, Video, and HDMI ports.
D
[Screen Fit] button
Adjusts the image so that two images are superimposed
correctly. See the following manual when superimposing
images for the first time after installation.
s Startup Guide
E
Numeric buttons
Enter the Password.
s "Setting Password Protect" p.48
F
[Auto] button
If pressed while projecting analog RGB signals from the
Computer port, you can automatically optimize Tracking,
Sync., and Position.
G
[Aspect] button
Each time the button is pressed, the aspect mode changes.
s "Changing the Aspect Ratio of the Projected Image"
p.39
H
[Num] button
Hold down this button and press the numeric buttons to
enter passwords and numbers.
s "Setting Password Protect" p.48
I
[Menu] button
Displays and closes the Configuration menu.
s "Using the Configuration Menu" p.56
J
[ ][ ][ ][ ]
buttons
x When the Configuration menu or the Help screen is
displayed, pressing these buttons selects menu items
and setting values.
s "Using the Configuration Menu" p.56
K
[ ] button
x When the Configuration menu or the Help screen is
displayed, it accepts and enters the current selection and
moves to the next level.
s "Using the Configuration Menu" p.56
Part Names and Functions
15
To Next Page
Loading...
