Device Configuration
This device is comprised of two projectors.
Name Function
A
Commander
Controls the receiver and combines two projectors. You
can perform projector operations from the commander's
control panel or the remote control. A sticker labeled "1" is
stuck to the base of the commander.
B
Receiver
When you operate the commander, the receiver performs
the same operations. A sticker labeled "2" is stuck to the
base of the receiver.
C
Stacker mount
This mount installs the commander and the receiver in a
stacked configuration.
Front/Top
The following example uses the commander. The receiver performs the
same operations.
Name Function
A
Air exhaust vent
Exhaust vent for air used to cool the projector internally.
Caution
While projecting, do not put your face or hands
near the air exhaust vent, and do not place objects
that may become warped or damaged by heat near
the vent. Hot air from the air exhaust vent could
cause burns, warping, or accidents to occur.
Part Names and Functions
9
To Next Page
Loading...
