One of the projectors is not turned on, or the projectors have not been linked together
Check Remedy
Are the commander and receiver connected correctly with a USB
cable?
Connect the commander's USB(TypeA) port to the receiver's USB(TypeB) port with a USB cable. Also, check that the
USB cable is not disconnected.
s Startup Guide
s "From Installation to Projection" p.32
Is Stack Mode set to Off? Commander: Set Stack Mode to Commander.
Receiver: Set Stack Mode to Receiver.
s Extended - Operation - Stack Mode p.61
Has an error occurred in the commander? If any errors occur in the commander, the receiver displays a warning message.
In this situation, the only available operation is to turn off the receiver. Press the [
] button on the remote control to
turn off the receiver.
Stop using the commander, and contact your local dealer or the nearest address provided in the Epson Projector Contact
List.
s Epson Projector Contact List
If you want to turn on the receiver only, hold down the [2] button on the remote control and then press the [t] button.
Has an error occurred in the receiver? If any errors occur in the receiver, the commander displays a warning message.
In this situation, the commander can be operated as normal.
Stop using the receiver, and contact your local dealer or the nearest address provided in the Epson Projector Contact
List.
s Epson Projector Contact List
If you want to turn on the commander only, hold down the [1] button on the remote control and then press the [t]
button.
Other Problems
No sound can be heard or the sound is faint
Check Remedy
Check that the audio/video cable is securely attached to both the
projector and audio source.
Disconnect the cable from the Audio port, and then reconnect the cable.
Problem Solving
78
To Next Page
Loading...
