Settings Menu
Submenu Function
Adjust
Commander Pos.
This is used when manually superimposing two images.
Pattern Color (Commander): Select the color for the pattern
used to denote the commander's projected image.
Pattern Color (Receiver): Select the color for the pattern used to
denote the receiver's projected image.
Start Adjustments: Starts the adjustments. A screen that allows
you to select the area you want to adjust is displayed.
Control Panel
Lock
You can use this to restrict operation of the projector's control
panel.
s "Restricting Operation (Control Panel Lock)" p.50
Submenu Function
Power Consump
tion
You can set the lamp brightness to one of two settings.
Select ECO if the images being projected are too bright, such as
when projecting images in a dark room or onto a small screen.
When ECO is selected, the power consumption and the lamp's
operating life are changed as follows, and fan rotation noise
during projection is reduced.
Electrical consumption: about 17% decrease, lamp life: about
1.25 times longer
When using at high altitude or in locations subject to high
temperatures, you may not be able to change settings.
Volume
You can adjust the volume. Setting values are saved for each
source.
Remote Receiver
You can limit the reception of the operation signal from the
remote control.
When set to Off, you cannot perform any operations from the
remote control. If you want to make operations from the remote
control, hold down the [Menu] button on the remote control for
at least 15 seconds to reset the setting to its default value.
User Button
You can select and assign an item from the Configuration menu
with the remote control's [User] button. Pressing the [User]
button directly displays the assigned menu item selection/
adjustment screen, allowing you to make one-touch changes to
settings/adjustments. You can assign one of the following items
to the [User] button.
Power Consumption, Info, Progressive, and Resolution
List of Functions
60
To Next Page
Loading...
