Epson EB-W16SK - Correcting the Focus; Adjusting the Volume; Selecting the Projection Quality (Selecting Color Mode)

A
Extend the rear foot.
B
Retract the rear foot.
Correcting the Focus
You can adjust the focus of the image by using the focus rings on the
commander and the receiver.
Adjusting the Volume
You can adjust the volume using one of the following methods.
x Press the [Volume] button on the control panel or the remote control
to adjust the volume.
[
a] Decreases the volume.
[
b] Increases the volume.
Using the remote control Using the control panel
x Adjust the volume from the Configuration menu.
s
Settings - Volume p.60
Caution
Do not start at high volume.
A sudden excessive volume may cause loss of hearing. Always lower the volume
before powering off, so that you can power on and then gradually increase the
volume.
Selecting the Projection Quality (Selecting Color
Mode)
Sets the color mode according to the surroundings. The brightness of the
image varies depending on the color mode selected.
Adjusting Projected Images
37